Search
Close this search box.

BC.OIL W – Mold Oil Based On Water

Mold separator based on mineral oils and water, creating a dry and polar surface after execution.

Share:

BC.OIL W mold oil is a water-based emulsion and a combination of neutralized vegetable oil and mineral oil materials, which is implemented based on new principles in the development of different generations of mold oil, such as being environmentally friendly, increasing the life of the molds, and the beauty of the concrete surface. It has been designed and developed for very high ease in separating the mold from concrete and cost-effectiveness.

Physical and chemical characteristics :

Physical state                                  liquid

Color                                               white

Density                                            0.95 gr/cm³

Flammability                                    Not flammable

Properties and effects:

Ability to dissolve in water

Ion Geller does not have

It does not ignite

Lack of adhesion of concrete or plaster to the mold surface

No discoloration on concrete surfaces

Simplicity and speed of execution

Ability to dissolve in water

Not flammable

Suitable for sliding molds

Preventing mold corrosion and increasing their lifespan

Compatibility with all types of metal, wooden and plastic mold surfaces

Application:

Lubrication of the surface of all kinds of metal, wooden and plastic molds

Lubrication of the surface of prefabricated molds with various designs

Surface lubrication of all types of sliding molds

Consumption:

Depending on the type of mold and environmental conditions, the consumption amount of BC.OIL W varies, and according to the required concentration of each liter of mold oil, mix 1 to 1.5 liters of water. Each liter of mold oil covers about 10 to 15 square meters of mold.

Technical points:

1- This product can be used alone or diluted with water.

2- The amount of water that you want to add should not be added to the mold oil at once, but the intended water should be poured slowly while the mixer is on inside the mold oil, otherwise it will cause two phases.

3- Reduce the amount of mixing water in hot weather or windy conditions.

4- In order to maintain the quality and effectiveness of the oiled surface, the contact time between the oil and the surface of the mold should not be more than 3 to 4 hours.

consumption instruction:

Before use, the surface of the mold must be separated and cleaned from any sticky compounds. New wooden molds must be covered with BC.OIL W mold oil in two steps. Before use, shake the material container well. This product can be used. It can be applied by different methods, by brush or spray.

Maintenance:

It can be stored in the original packaging and in a covered warehouse away from direct sunlight at a temperature of 10-30 degrees Celsius for one year after the date of manufacture.

packing:

20 liter gallon

safety tips:

This material is not flammable and is not harmful to the environment. Avoid contact with eyes and skin. In case of contact with eyes, wash with plenty of fresh water. It is recommended to use protective glasses and gloves while working. If swallowed, consult a doctor immediately.

Related Products

Reviews

There are no reviews yet.

Be the first to review “BC.OIL W – Mold Oil Based On Water”

Your email address will not be published. Required fields are marked *