Search
Close this search box.

Watershock WP600

Immediate sealing of concrete surfaces, increasing the setting speed and resistant to moisture

Category:
Share:

watershock wp600 is a quick and powdery waterproofing material based on Portland cement, which is used for sealing, filling cracks and holes in concrete. This material is used in parts of the structure where there is severe leakage and high water pressure. As a result of mixing with water, AniGir becomes a powerful paste and accelerates the initial setting due to the increase in hydration speed.

Physical and chemical properties

Physical state                                powder

Color                                           Gray

Density                                            1.2 gr/cm³

Application Temperature              +5 °C to +35 °C

PH                                                       13-14

Chlorine ion                                   No (BS 5075)

Pressure Strength                           30 minutes ≥ 6N/mm

24 hours ≥ 10N/mm

28 days ≥ 30N/mm

Properties and effects:

Increase the speed of the initial setting in less than 1 minute

No shrinkage and surface cracks

The possibility of operating the closed structure in the shortest time

Resistant to moisture and dampness

easy to use

Fast adhesion to all cement surfaces such as concrete, stone and brick structures

Application:

Blocking any positive and negative water leaks

Repairing damage to structures such as pools, reservoirs, ponds and tunnels

Fast repair and sealing of elevator holes, pipes and water channels

Compliant with the standard:

ASTM C928-05

Amount of consumption:

The consumption amount of  watershock wp600is based on the cross-sectional area and conditions of the leakage site and considering the specific weight of the shock absorber. The mixing ratio of Ani Geer with water is 3 to 1.

Usage method:

Cut the intended area in a V shape and clean it from any loose and waste materials. The most suitable mixing method is manual stirring (with gloves). First, pour the desired water into a container, then slowly pour the calculated amount of watershock wp600 powder into the water container and continue mixing until a homogeneous paste is obtained. Immediately fill the seam with your hand (with gloves) or with a suitable tool from the periphery towards the center and press for 15-20 seconds. Then, in order to level the work, scrape off the excess amount of mortar.

Always mix enough ingredients that you can do the job in less than 20 seconds.

Use a drain pipe to transfer water in areas with major damage. Apply mortar around the pipe using SHOCK N61 and then remove the pipe itself and block the pipe again with the above method.

Maintenance conditions:

It can be stored in the original packaging and in a covered warehouse away from moisture and direct sunlight at a temperature of 10-30 °C for one year after the date of manufacture.

Type of packaging:

Packages of 5 kg

Safety tips:

This material is not flammable and is not harmful to the environment. Avoid contact with eyes and skin. In case of eye contact, wash with plenty of water. It is recommended to use protective glasses and gloves while working. If swallowed, consult a doctor immediately.

Related Products

Reviews

There are no reviews yet.

Be the first to review “Watershock WP600”

Your email address will not be published. Required fields are marked *